Aluminum extrusion for table-saw guide?

[Sam I Am]

Ok sorry not really bike stuff but can anyone help please.
I am trying to make a new saw Rip Fence for a large table saw and wanting to find some stiff aluminum extrusion and possibly some 10mm thick teflon strips to stick to it . Does anyone know a good place that isn't going to cost me a fortune in aucks

thanks sam

[BMWST?]

i know in welly that you can go to ulrich aluminium (large supplier of aluminium extrusions)and rumage through the offcut bin and by bits cheap....dunno about the teflon/nylon

[Sam I Am]

BMWST? thanks for that it would be just what i want... I may try there auckland branch.

[hayd3n]

try someone like mulford plastics for the teflon its expensive tho why not uhmwpe?
or hdpe
or HMWPE
Ultra High Molecular Weight Polyethylene (UHMWPE) is often referred to as the world’s toughest polymer. UHMWPE is a linear high density polyethylene which has high abrasion resistance, as well as high impact strength. UHMWPE is also chemical resistant and has a low coefficient of friction which makes it highly effective in a variety of applications.




HDPE
High Density Polyethylene

High Density Polyethylene (HDPE) is more rigid and harder than lower density PE’s. Its tensile strength is four times that of LDPE and its compressive strength is three times better. Compared to UHMWPE it has approximately 1/3 the wear resistance and 1/2 the impact resistance.



HMWPE
High Molecular Weight Polyethylene

High Molecular Weight Polyethylene (HMWPE) is a high density polyethylene with a molecular weight of 500,000g/mol. This gives it better wear, impact and abrasion resistance than HDPE but it does not achieve the superior performance of UHWMPE.

all found from
http://www.supplyservices.co.nz/plastics.htm

[Sam I Am]

DAMN hayd3n you know your plastics thanks alot, here was no real reason for teflon other than i didnt know about other plastics.. looking at supplyservices now.

thanks so much.

now if only i can find som groved alumimum i will be sorted.

[Sam I Am]

WOW UHMWPE sounds amasing stuff !!!

[Sam I Am]

something like this

[hayd3n]

yea places lke ulrich aluminium shoud be able to take care of ya for the stock

[icekiwi]

Micro Wakefield on Nielson St Onehunga will be your best bet...
They do all sorts of extrusions and plastics..

[Sam I Am]

thanks guys, i have been looking at there websites and cannot see andy large slotted stuff but i will give them all a call.

thanks again
sam

[nadroj]

Looks a bit like the office partition posts.

[Sam I Am]

Looks a bit like the office partition posts.

OH yes i was wondering where i had seen somting like this... i think thay have rounder corners but i will look into it.

[Sam I Am]

I Found it !!!

http://www.linearbearings.co.nz/

this stuff is amazing just a shame 80mmx80mm box is about $250 per meter

[Madness]

Try giving these (http://www.chevpac.co.nz/webshop/CHVHome.csp) guys a call.

[Sam I Am]

Madness nice link thanks....