Snapped clutch cable

[rabidnz]

:argh:is there anywhere in chch to buy the brass clutch cable terminators for me to solder on or does anyone have any i could buy off them??? I also need some inner cable can that be bought seperately?
Cheers all

[rabidnz]

PS this is what clutch end fitting looks like. I thought the handle end fitting was soldered on so i heated it up but it was just a slug of solder which quickly became a puddle. Now im not sure whether to try and remove the clutch end of the cable in case it too turns to goo. Im sure i can jury rig something together ..

[JMemonic]

Not a lot of change today, you could try some of the brake shops perhaps.

[imdying]

Sorry, didn't see this yesterday, yes can help... you just want a new end?

Easiest way is to go into Safe R Brakes on Fitzgerald Ave and ask Guy or Gary to sell you what you're after.

[Motu]

Make your own - for normal barrel lever end nipples I just use an 8mm bolt cut to length and drill a hole.The other end can be harder,some really small dia tubing is good...or again,just use a small dia bolt.

[rabidnz]

hey cheers mate, tried the bolt trick , cant get the *** to solder, some brass tubing , now thats what i need. Hmm i think even acorn models might have it

[imdying]

You a bit slow or something? Why waste your time when you can get it off the shelf right now :rolleyes:

[Richi]

You a bit slow or something? Why waste your time when you can get it off the shelf right now :rolleyes:

Doubt it will cost more than 20 bux too :cool: