Project Bikes

It worked. Now needs a really good tuning and all will be SWEET. Have a look at this for proof;

http://www.youtube.com/watch?v=GYAX_5wKV14

I ended up finishing at 1 am this morning fixing the swivel I made so I can race shift (the aluminum plate kept coming of the bearing), modifying the exhaust (didn't fit no more) and carrying on with my forever battle f keeping my garage tidy.

Headed inside to sleep and couple hours later I'm awake (yet again) obsessing over the exhaust. F(*k. i really must get a handle on this obsessive behaviour disorder.

Engine's running.

Couple of things to remember for next time;
Make sure I check I have put all the parts back and in the right order. Having such spares are not a good idea.

Don't be surprised if you customize parts they won't fit when you something this amount they won't fit.

I'm happy though. The engine pretty much fired up straight away. With any luck I will be able to ride the bike tomorrow.

Realized after fitting most of the parts I'll have to take the engine out to replace one of the cam chain runners.

Got the engine back from the engine re-conditioners with new gudgeon pin and studs sorted. I then took the bottom end down to local bike shop to try and get the flywheel off and to our frustration the puller they have was too deep, so I went and tried to order one with no luck. Following a couple hours of procrastinating when I got home I strated putting the engine back together again. Enjoy the pics with a couple comparing the CBR125 and 150 cylinder and heads. Sorry I didn't get a pics of the ...

Attached Thumbnails

       

I have started an album of all the work I have been doing to Zensen. I'll keep adding as I find more photos

[Spend the day finishing stripping Zensen back, cleaning and polishing parts, drilling out the rear sprocket and putting it all back together. Great fun and learning curve of what is going where and with the changes I've made how I can run things better. But man I'm over the the smell of polish. Well worth it.

Check out the photo's. Will add more later.

Attached Thumbnails

           

Inspired by CG125 Bucket Project thread in the buckets forum I have decided to strip the chassis back (apart from the steering head) and clean it up. With the engine is out it is the prime opportunity to do some serious cleaning and making the bike look as good as I can. It will give me a chance to get rid of all that annoying surface rust and paint up the other parts/modifications that I made for the bike but never did anything about painting.

I'll post photos later.