Stink Racing

I've had a few offers of brake calipers since my last post. If you think you can help it's a ZXR250A right hand front caliper complete with the mount (which holds the pads). Below are pics of a left hand caliper.


Anyway - got the thing running last night.
I took the mains out and hooked everything up. After much kicking without result I went over everything with #1 TDC (remember this) ...

I have spark.
The chambers are fitted.
I have made the throttle cables.
The clutch is connected and working.
The top fairing is on it's way.
I have found a front brake caliper (no money to spare for it though)
A little work to do to the carbs and we'll see if it runs.
Then it's tuning time!

I have fitted a RD-LC flywheel and stator with two pickups from an RGV VJ21.
I'm planning on using the stator to supply power to to the CDI.

My question is how to wire this up.

My guess is to run the three stator wires to the Rectifier. There are two wires out - Red and Black/White. Red I'm guessing is + and the Black/White is (-).

On the CDI I've sorted out the coil wires. What's left is a Black/Yellow (tacho), Black/White (-), and Orange/Black. ...