gatch

Have been doing some research into f3 racing regulations.

From what I can gather it will be eligible to race in club level f3 racing !! Competitive ? Probably not, but I'm gonna do it anyway.

Made some small changes to the chassis, nothing major as my financial situation is about the same as a bath that has just finished emptying, there is nothing left..

Things are on the up however and the future is look brighter..

Stay tuned..

More bits and pieces pulled off and filed under R (ugly oem catch bottle, wire brackets for hoses, other brackets, pillion peg mounts, grab rails, headlight support etc)..

Switch gear is gone, foot rests and brakes have been pulled for cleaning, new pads, fluid and braided lines are on the list.

After realizing that the engine was a stressed member it looks like I may need to fabricate some rails to go in between the front and rear engine mounts.

Also ...

More bits and pieces pulled off and filed under R (ugly oem catch bottle, wire brackets for hoses, other brackets, pillion peg mounts, grab rails, headlight support etc)..

Switch gear is gone, foot rests and brakes have been pulled for cleaning, new pads, fluid and braided lines are on the list.

After realizing that the engine was a stressed member it looks like I may need to fabricate some rails to go in between the front and rear engine mounts.

Also ...

A few months ago now I killed the motor in my Spada, being that the reg has long since lapsed I'm not going to worry about putting it on the road again. I came to the conclusion the remains aren't worth much at all so will employ my engineering talents and turn it into a track scoot, WITH A XR650 ENGINE TRANSPLANT WOO DE DOO !!!

It will be a while until I can afford a new motor so in the mean time I'll pretty much be pulling the chassis, brakes and suspension apart to give it all ...

I seem to do it a lot, without even realizing even.
Like my plans to buy a vfr, when is that going to happen.. I'm fuckin broke !

I've got a project bike in pieces that needs a new motor, which isn't going to be too costly (well I hope) as I can do nearly all the work myself, I'm still servicing a fuckin bank loan, then there is a hefty tool account to pay off (quality tools are hellishly expensive), a tax bill, probably several hundred illegitimate babies with mohawks and ...