• Most Active Threads

    TZ350

    ESE's works engine tuner

    Thread Starter: TZ350

    . This is Thomas a Vietnamese race mechanic, you know that place where they have all those hot 50's and 125's are big bikes. Thomas, ESE's Race Team's Tuner is fettling number 9. adjusting the port timing for Taupo. Its hard to see but he has taped a degree wheel to the magneto flywheel...

    Last Post By: TZ350 Today, 07:42 Go to last post
    speedpro

    #6

    Thread Starter: speedpro

    #6 is dead. Long live #6. After 17 years.

    Last Post By: speedpro Yesterday, 18:14 Go to last post
    Ian Staples

    pissed off with hjc helmets

    Thread Starter: Ian Staples

    I all ,Just a bit of a rant here. rang local dealer to get new visor for a hjc rpha10 and was told that hjc helmets have a life span of 5 years therefore they don't make visors for them any more. is this normal for other brands ??As it turns out Mine was actually a 10 plus (next model ) so there...

    Last Post By: TheDemonLord Today, 11:38 Go to last post
    FZR-Spaz

    FZR Manual Clutch Conversion

    Thread Starter: FZR-Spaz

    Hi All, New to the forum and didn't know if to put in here or the prototyping area, I have previously some talk on this but couldn't find it. I am wanting to convert from hydraulic clutch setup to manual one and figured someone might have some good information. I have seen a few kits...

    Last Post By: pete376403 Yesterday, 18:25 Go to last post
    dunnas52

    Powder coating northland?

    Thread Starter: dunnas52

    Are there any good powder coating places in northland?

    Last Post By: typhil01 Yesterday, 18:26 Go to last post