Up then down then up again.
by
, 10th November 2010 at 21:43 (788 Views)
Got the engine back from the engine re-conditioners with new gudgeon pin and studs sorted. I then took the bottom end down to local bike shop to try and get the flywheel off and to our frustration the puller they have was too deep, so I went and tried to order one with no luck. Following a couple hours of procrastinating when I got home I strated putting the engine back together again. Enjoy the pics with a couple comparing the CBR125 and 150 cylinder and heads. Sorry I didn't get a pics of the valves but my camera is doing the dying act.