.
This is Thomas a Vietnamese race mechanic, you know that place where they have all those hot 50's and 125's are big bikes.
Thomas, ESE's Race Team's Tuner is fettling number 9. adjusting the port timing for Taupo.
Its hard to see but he has taped a degree wheel to the magneto flywheel...
Alright then you homo's in order to save a 100km round trip to the Albany Pub and avoid the attention of the filth I'm organising a South Auckland Thursday Night Ride.
Organising being a loose description. I have a route in mind, sadly I don't know where the pubs are around south yet but I will...
Moving on from Ecotrons, and Ecotrons is past history now I am moving forward with a Speeduino for my 2T two stroke EFI project.
https://speeduino.com/wiki/index.php/Speeduino
The mission is to find a way of taking a MAP value from the varying pressures in my two stroke crankcase so I can use...
https://www.stuff.co.nz/national/123849914/its-not-the-tourists-road-death-toll-virtually-unchanged-from-2019-despite-border-closures
I have suspected this all along. Kiwi drivers are not as competent as they believe they are. In fact, my most recent road trip also supports the notion. In some...
So on my way home today was happily riding along, everything normal, when the bike cut out altogether and I had to coast to the side of the road.
The bike was completely dead, no dash lights, nothing. No response to turning the ignition key, nothing from the starter. I checked the battery...
Hi guys, not long started a full nut and bolt resto of a 1984 fj1100
Tyre choice is limited for 16’s standard rear 150/80-16 anyone out there with opinion on going a bit wider?
Hi all,has anyone fitted a booster plug to a 2v monster to try to even out the low throttle roughness? or is this just a ducati traint I have checked/adjusted the obvious things.
Poll Widget
ESE's works engine tuner
Thread Starter: TZ350. This is Thomas a Vietnamese race mechanic, you know that place where they have all those hot 50's and 125's are big bikes. Thomas, ESE's Race Team's Tuner is fettling number 9. adjusting the port timing for Taupo. Its hard to see but he has taped a degree wheel to the magneto flywheel...
Last Post By: husaberg Today, 16:45