.
This is Thomas a Vietnamese race mechanic, you know that place where they have all those hot 50's and 125's are big bikes.
Thomas, ESE's Race Team's Tuner is fettling number 9. adjusting the port timing for Taupo.
Its hard to see but he has taped a degree wheel to the magneto flywheel...
The foundry or metal casting stuff thats been going on the the ESE thread really inspired me to get on with having a go at this stuff.
If you can cast metal theres really not much you cant do. I dont think its going to be easy, most of it has been a bit of 2 steps forward 1 step back so far.
Im...
Rules are easy...and borrowed from Waikato!
#1 - Find the tag and reproduce the photo (as best as possible). The first person to post a found tag gets to place the next tag. If you get a tag, but somebody else posts their picture first, you lose.
#2 - Take the tag to a new location (location...
I am new to the forum so bear with me on posting issues.
Over two years ago, having just restored an old GT750, I decided it might be fun to take one of those bikes and push the design as far as I could.
Two years down the line and pending paint and final EFI work I have this.....
I...
So on my way home today was happily riding along, everything normal, when the bike cut out altogether and I had to coast to the side of the road.
The bike was completely dead, no dash lights, nothing. No response to turning the ignition key, nothing from the starter. I checked the battery...
Hopefully someone on here can help me out, iv recently acquired an old 1982 XS400RK for a steal and am looking to get it back on the road. the only problem is that its an old farm bike and the guy I got it off has no history on it. no plates, no knowledge on previous registered owner etc. I'm going...
Poll Widget
ESE's works engine tuner
Thread Starter: TZ350. This is Thomas a Vietnamese race mechanic, you know that place where they have all those hot 50's and 125's are big bikes. Thomas, ESE's Race Team's Tuner is fettling number 9. adjusting the port timing for Taupo. Its hard to see but he has taped a degree wheel to the magneto flywheel...
Last Post By: philou Yesterday, 23:13