• Most Active Threads

    TZ350

    ESE's works engine tuner

    Thread Starter: TZ350

    . This is Thomas a Vietnamese race mechanic, you know that place where they have all those hot 50's and 125's are big bikes. Thomas, ESE's Race Team's Tuner is fettling number 9. adjusting the port timing for Taupo. Its hard to see but he has taped a degree wheel to the magneto flywheel...

    Last Post By: Frits Overmars Today, 09:21 Go to last post
    Owl

    Tag o rama!

    Thread Starter: Owl

    Rules are easy...and borrowed from Waikato! #1 - Find the tag and reproduce the photo (as best as possible). The first person to post a found tag gets to place the next tag. If you get a tag, but somebody else posts their picture first, you lose. #2 - Take the tag to a new location (location...

    Last Post By: banditrider Today, 08:07 Go to last post
    Morgan

    Project : French road racer in New Zealand had questions !

    Thread Starter: Morgan

    Hi everybody, I'm a 32 french road racer. I would like to come in New Zealand in 2019 with my family to race on the Cemetary circuit. My project is not very simple... My friend Fabrice Miguet expected to come this year, but unfortunately, he died at the Ulster GP in July. His dream was to race...

    Last Post By: Morgan Today, 00:21 Go to last post
    arpa

    Yamaha XV500 project- piston ring question

    Thread Starter: arpa

    Hi All, I drifting further and further in my recently obtained Yamaha, as it has more issues than I expected. Engine apart, replacement crankshaft and con rods on the way from Ebay, also crankshaft bearings as well.. as is usual, I started to think about replacing all parts which is accessible now,...

    Last Post By: F5 Dave Yesterday, 16:58 Go to last post
    jellywrestler

    old progams

    Thread Starter: jellywrestler

    hi folks, i'm looking at doing a book on circuits through time in new zealand and keen to acknowledge bucket racings contribution to motorcycle racing. I'm covering fixed circuits like manfeild and the cemetery circuit not open carparks or areas that were set out with cones so keen to see if any...

    Last Post By: Kickaha Yesterday, 22:09 Go to last post
    jthespanner

    TS125 Powered Bucket

    Thread Starter: jthespanner

    Hello Lads and Ladess's I have recently built a new bucket bike specs as follows. 1989 GSXR250 (GJ72) frame Front forks stripped and rebuilt, 20w oil, extra pre-load on springs Standard rear shock. GSX1300R Rear sets with custom solid pegs and sliders. 13mm GN125 front Master Cylinder...

    Last Post By: jthespanner Today, 12:20 Go to last post
    nzspokes

    Good gravel/beach riding in the far Norf?

    Thread Starter: nzspokes

    We are heading up to stay in KeriKeri in a couple of weeks for a few days. Might take the ADV bikes up on the trailer and go for a ride one of the days. Thought about 90 mile beach but the tides look wrong. Any ideas from the locals?

    Last Post By: glitch_oz Yesterday, 19:21 Go to last post
    Laava

    Bmw s1000r

    Thread Starter: Laava

    I went for a ride today to Pataua north with the guy I bought my gixxer 750 from. On the return trip, he was keen for a nostalgic trip into town. Poor me, I had to ride his brand new BMW for him. Thankfully it has been run in so the restrictions have all been removed! Holy fuck! This is a hoon...

    Last Post By: Scubbo Today, 14:35 Go to last post
    nzspokes

    KDX200 carb, anybody got one?

    Thread Starter: nzspokes

    My KDX200 carb just decided to snap the plastic choke unit off and was hoping to take it out on the weekend. Anybody in Aucks got one?

    Last Post By: nzspokes Yesterday, 20:45 Go to last post
    speedpro

    Bike down & the towies

    Thread Starter: speedpro

    At the end of Universal Drive just before Lincoln Road I noticed a bike on it's side all broken(front end) just where I turned into the shopping centre. I suspect it was the old zooming between rows of cars just by the mall entrance and somebody puller in/out and he was collected. No obvious rider....

    Last Post By: jasonu Today, 14:25 Go to last post