Suzuki engine dismantle tool?

[Cajun]

Hi

though someone might help i have a spare engine in my garage i want to finish stripping down

I am after something to do the below jobs the suzuki manual says they are a clutch holder and a rotor holder & rotor remover

Anyone know of of where can get these tools, or what they are also know off, or simlar.

[quallman1234]

You can use a rattle gun and a rag, for the clutch basket.. Its not too bad on it.

[paturoa]

Squiggles helped me out with the clutch basket tool http://www.kiwibiker.co.nz/forums/sh...ad.php?t=98019

Fylywheel is still on it as I didn't need to take the crank out.

[Dodgyiti]

The pictures give a good enough indication of what you need to make.
By the looks of it you only need a drill, hacksaw, files and vice to make what is required.

I would not try the rattle gun method, damage to the nut will only end in tears when the proper solution is so straight forward.

Last weekend I had to do a simmilar job- hence a mate who was around on the day pointed me to this thread.
(Just in case you think I am waffling without any real experience)

[KiwiGs]

For the clucth hub holder use an old steel to make one of these.