Stripped screw on the brake reservoir?

[vindy500]

How do i go about removing it? i dont really want to destroy the the thread

[Max Preload]

Ummmm if it's stripped the thread is already destroyed. Or do you mean the head is rounded? If the latter, see here.

[vindy500]

like the bit you put your screwdriver in is buggered

[Max Preload]

So the latter. See the post.

[vindy500]

aiight but how do i get the main part of the screw out once the heads off?

[Max Preload]

aiight but how do i get the main part of the screw out once the heads off?

The threaded section does not stop flush with the reservoir - it's proud. Drill in the centre of the head with a bit that is the same diameter or very slightly larger than the machine screw's thread and stop as soon as the head pops off (it'll be a ring) and there will be enough thread remaining to put long nosed pliers on and remove the threaded piece from the reservoir once you remove the cap and seal.

Oh, and get a new machine screw first to replace it.

[vifferman]

Oh, and get a new machine screw first to replace it.

Oh, and put a smear of grease or oil on the threads before you replace the screws. Brake fluid's great for causing corrosion between steel screws and alloy brake fluid reservoirs (sucks up moisture, galvanic corrosion ensues). Since it's difficult to stop the brake fluid getting in the screwholes, next best thing is to protect the threads.

[Madness]

Depending on how badly munted the head is, Recoil (the thread insert people) produce a solution called re-grip. It's a paste that you apply to a screwdriver tip to grip onto stripped heads. It works.

Try Engineering Supplies in Petone 568 5048, they're just off The Esplanade & easy to find. Say Hi to Wayne for me.

[Max Preload]

Here it is step-by-step.

[The Pastor]

Also if you clean it up real well, some times you can epoxy like an allen key or somthing to the head of stripped screws - worth a shot if youve got some epoxy lying around, if not get a drill / easy out

[vindy500]

got it out with a drill, thanks guys

[TLDV8]

like the bit you put your screwdriver in is buggered

Get a small centre punch,put a small punch mark at the outer part of the fastener then angle the centre punch in that mark and tap it around with a small hammer.

Edit..Didn't see the last post,bit late for the above now.

[vindy500]

i just stripped the second screw... weak screws or poor technique on my behalf? meh get some more tomorrow

[Max Preload]

i just stripped the second screw... weak screws or poor technique on my behalf? meh get some more tomorrow

Most likely poor quality screwdrivers or you're using phillips screwdrvers and they're pozidrive heads. They look very similar, but pozidrize addresses the shortcomings of phillips heads.

Phillips screwdrivers come to a sharp point at the tip, while pozidrive are flatter.

[vifferman]

Most likely poor quality screwdrivers or you're using phillips screwdrvers and they're pozidrive heads.

Pozidrive aren't generally used on bikes.
It's more likely the screw head and/or screwdriver tip were a bit munted. The trouble with Phillips is that if either item isn't in pristine condition, and/or they're not mated properly, slippage occurs.
But you knew that.
And those screws on the reservoir covers are very small, so there's not much contact area or grip.
Wonder if you can replace them with s/steel allen headed ones?