Results 1 to 1 of 1

Thread: 07 R6 Drive Sprocket 'Chain Guide'

  1. 5th March 2010, 22:56 #1
    Toast's Avatar
    Toast
    Toast is offline Hone made me
    Send a message via ICQ to Toast Send a message via MSN to Toast
    ♂
    Join Date
    2nd February 2005 - 13:41
    Bike
    600RR3
    Location
    Auckland
    Posts
    2,684

    07 R6 Drive Sprocket 'Chain Guide'

    Hello

    I've got a race this Sunday at a Puke. Last time I was there I was on 16/43 and bike was over-revving a bit much, especially when rolled in to the kink near the end of the straight

    I got a 17T front sprocket and it goes on fine but I need to remove the 'chain guide' piece and the drive sprocket cover.

    Is it fine to run without the guide there? (piece 30 in the attached parts fiche diagram)

    Also of note, the offset on the 17T sprocket seemed fractionally greater than the one I took off, probably about 1mm difference. Everything seemed to remount and tighten up wtihout any unusual stress. Should I still be concerned?

    Cheers!

    Phil
    Attached Thumbnails Attached Thumbnails Click image for larger version.  Name: 18081_crankcase..gif  Views: 6  Size: 37.3 KB  ID: 199406  
    ...
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules