GSXR750 slabbie garage cleanout

**robinm** · 11th April 2010, 13:19

Having a cleanout of the garage. Lots of slabbie parts lurking in there.
a selection of new and used parts can be found here
http://www.trademe.co.nz/Members/Lis...?member=190644
Plus a lt more that I have not listed, just ask, I may have what you are looking for.

**FruitLooPs** · 13th April 2010, 20:40

Hey Robin,

I got the rod off you yonks ago for my bike. Don't suppose you happen to have some barrels that are in good knick with reasonable km's on them (under 70 thou or so) ? I've got some rings on the way for mine, which are in spec but getting on a bit.

**robinm** · 13th April 2010, 21:54

The only barrels I have need one cylinder resleeved, the other 3 cylinders are real good.

Click image for larger version.

Name: piston..jpg
Views: 24
Size: 192.2 KB
ID: 204129

**FruitLooPs** · 14th April 2010, 19:54

Hmm how many km's on it roughly? don't happen to have bore measurements do you?

Cheers

**robinm** · 18th April 2010, 20:31

Sorry, no bore measurements, I do not have an internal micrometer, but is off the same motor your rod came from. No lip on top of bore at all, so I would consider them good, well worth putting another sleeve in to reuse the set.

**robinm** · 25th April 2010, 18:22

Still got lots of bargains, how about a complete set of new disc pads, front and rear, for GSXR750-1100 slabbie $60.00, that's got to be a bargain.
Or how about a set of new clutch plates and H/D springs for $60.00

**Pumba** · 25th April 2010, 21:08

Dont surpose you have any carb parts? VM29ss. Looking for some parts that the throttle cable goes into

**Laava** · 25th April 2010, 21:56

Mate I have yet to investigate what more I need, this coming sat will be the day! Will try to get the bitch going before terminal stripdown and then will find out if I need a clutch and brakes!