As per above. Got an alloy end cap I need to turn down, also need to make some nylon/urethane bar ends.
Payment in beer.
For whom the bell tolls
As per above. Got an alloy end cap I need to turn down, also need to make some nylon/urethane bar ends.
Payment in beer.
KiwiBitcher
where opinion holds more weight than fact.
It's better to not pass and know that you could have than to pass and find out that you can't. Wait for the straight.
Hardcore Biker
I have one - how tekernikal is it?
Have you not the nylatron bar?
(\_/)
(O.o)
(> <) Peace through superior firepower...
Build your own dyno - PM me for the link of if you want to use it (bring beer)
For whom the bell tolls
Just gotta remove some material from an exhaust end cap.Originally Posted by geoffm
Don't have the nylon as of yet.
KiwiBitcher
where opinion holds more weight than fact.
It's better to not pass and know that you could have than to pass and find out that you can't. Wait for the straight.
Forum whore
Pussy.
Shervin wouldn't need a lathe.
Bouncy...bouncy..
rotfpmsl..
"No matter what bike you ride. It's all the same wind in your face"
For whom the bell tolls
LOL
I don't pray to Allah so I won't to get the job done properly.
KiwiBitcher
where opinion holds more weight than fact.
It's better to not pass and know that you could have than to pass and find out that you can't. Wait for the straight.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks