Hyosung gt250r horn button ignition feed?

[born disturbed]

I have a 2007 GT250R which I am installing a set of Daytona Hot Grips onto. I am looking for information on the colour of the wire which feeds the horn button to bridge onto a relay (which is located in the front fairing) to prevent the grips from running while the ignition is off or any other ideas that you good ole ingenius types may have.

I have searched high & low for a wiring diagram for this bike & come up with sweet fuck all, it is the final wire I need to get it running & put the fairings back on & go for a blat with warm hands

Anyone else installed hot grips on one of these before, help please

[NJ83]

I believe you can download the entire workshop manual for most of the Hyosung range of the korider site.

Or try here.... http://www.scribd.com/doc/16066620/H...orkshop-Manual

[kewwig]

You can run the relay coil from any live feed. Up front tap into your low beam circuit, or if the relay is under the seat, go for the taillight circuit. Easy to find as you just work back from the bulb

[born disturbed]

Cool thanks guys, I had looked on Korider but couldnt spot a diagram that I could actually download correctly. I have found the wire thanks for the link

The reason Im intending to use the Horn feed is I want to run this relay & possibly one other for an LED emergency light kit without overloading the system. Ride safe all

[karmobRob]

Any Ignition switched source is good,from fuse box is OK.And put the earth on the frame,not forward of steering head!
Cheers ROBERT