So i have an Honda CBR 250 MC19
Looking to get a new exhaust but i dont want stock
Unfortunately The MC19 is a one piece so i will have to cut it and weld a new exhaust on...
Any info?? is there aftermarket MC19 axhausts?
So i have an Honda CBR 250 MC19
Looking to get a new exhaust but i dont want stock
Unfortunately The MC19 is a one piece so i will have to cut it and weld a new exhaust on...
Any info?? is there aftermarket MC19 axhausts?
Hey i was planning on putting a screaming demon MC22 exhaust on mine over the summer, you'll need to cut the exhaust off and weld on a flange onto your exhaust, you can than bolt on an MC22 exhaust straight onto the flange.
I ordered the flange in off ebay for $35 last week but than i decided not to go ahead with it. The flange is still on the way here from aus but if you want it you can have it for $30 since i dont really need it anymore.
I also bought a derestricted CDI for my bike, still havnt got it yet but cant wait
I thought you were selling your bike??
Oh i am selling it but again, I want to make it fancy for the last couple of months of my use. haha people dont seem to understand that i love my bike haha. i may take you up on that offer mate! ill get back to you soon
also what about the airflow? will i need new jets? and how about the fittings? will it actually fit on? or will i need to make new brackets?
Don't bother putting an aftermarket muffler on it, just drill some holes in it. Check out the Club 250 forum and have a look what I did on mine. It sounds really nice.
you may need to get the jetting done but when i asked the screaming demon guys they said i shouldnt need to tune it. yeah it will fit right assuming you get it done professionally since they need to align it properly and clean the pipes before welding just so that it isnt leaning off to one side and it welds on properly.
i was gonna check the jetting anyway after i put the exhaust on and get the valve clearances checked and carbs cleaned while i was at it. i doubt the jettings need to be changed but they arnt too expensive to do if you do it yourself.
lol DAMNIT you're tempting me to do it!!! agh lol yeah i really wanna upgrade my exhaust but i cant seen to decide if i should do it or save up for my next bike.
yeah only do that if you're planning on losing craploads of value on it when you come to sell it. while aftermarket exhaust tend to actually keep their value.
Either way I HAVE to replace the MC19 exhaust. the current one is a bit scratched up. Just weighing up my options,
Is it cheaper to:
A, Just replace the exhaust with another Stock MC19 system
or
B, Cut the end, weld a flange on and chuck an MC22 or after market exhaust on
well i know that a new Exhaust system for an MC19 is around $200 for a nice conditioned second hand one.
I dont really mind going second hand Stock but i would prefer an aftermarket Exhaust for a little bit extra.
yeah... i need to get a quote on the price to cut it, weld it and put an new exhaust on... then i will need to find an exhaust.. Any ideas? Im keen for that flange mate!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks