RGV250 powervalve modification

[explode64]

Hi All
Does anyone in NZ do the RGV250 powervalve modification where a machined pin is pressed into the powervalve center. It is the moficication commonly seen on the http://www.rgv250.co.uk/forums web site where there is a pin that has 2 3.75 lugs either side of a 9mm centre that is pressed into the centre powervalve part that is drilled to suit the 9mm part of the pin.

[DEATH_INC.]

get hold of Rodders (pm may work...) he knows all there is to know about these things

[eelracing]

Boss Engineering here in Wanganui did a similar service for me.I can recommend as it took all the slop out of the buggers.

Give Hugh a bell...06 348 9516

[rabidnz]

how much would I expect to pay for this service chaps?
provided i removed the valves myself

[explode64]

Im having them made up at the moment by motorsport engineering. Used the drawing on the rgv forum. With any luck will be all going by the weekend