Results 1 to 9 of 9

Thread: Canyon Dancer Bar Harness II

  1. #1
    Join Date
    13th April 2009 - 20:17
    Bike
    2010 Yamaha R1
    Location
    Wellington
    Posts
    69

    Canyon Dancer Bar Harness II

    Hello all,

    I just received this bar harness Thought I'd post up a first impression for ya.

    They're are very very good quality.
    Fit my 2010 R1 no worries.
    Note that they don't come with tiedowns
    Bought from Motomummy along with a speedoDRD (also very nice product).

    I'd recommend both these things hands down.

    I'll be taking my bike down to the south Island over NYs, so will look at posting a more experience driven review on my return.





    ()()
    ( ';')
    ( (")(")
    O O

    Bunnies on motorcycles for life!!!!!

  2. #2
    Join Date
    8th January 2005 - 15:05
    Bike
    Triumph Speed Triple
    Location
    New Plymouth
    Posts
    10,218
    Blog Entries
    1
    I have a product "Bike bra?" which does the same job as the bar harness but doesn't have any plastic bits.

    Presumably either would do the job.

  3. #3
    Join Date
    13th April 2009 - 20:17
    Bike
    2010 Yamaha R1
    Location
    Wellington
    Posts
    69
    Quote Originally Posted by pritch View Post
    I have a product "Bike bra?" which does the same job as the bar harness but doesn't have any plastic bits.

    Presumably either would do the job.
    Yeah man. Totally.

    I first bought the bike bra and found that I couldn't get the angle right without it coming into hard contact with the fairings. Also, I have very soft gel grips that suffer under the direct contact point of the Bra system.

    The CD I is the same system as this. The CD II is the one with the 'plastic cups'.

    So, the main selling point for me with the CD II was that the tie downs start further along the end of the handle bars, allowing you to get a more vertical angle, subsequently stopping it coming in contact with the fairings and saving the hassle of havin to pad the shit out of the tie downs to stop 'em scuffing your precious bike. And they are more gentle on your grips.

    I also found the material and construction was significantly more sturdy. But as you said, they both do the job and are sweet products.

    Chur

    But, I'll be sure to report back after my trip down south
    ()()
    ( ';')
    ( (")(")
    O O

    Bunnies on motorcycles for life!!!!!

  4. #4
    Join Date
    24th October 2007 - 08:19
    Bike
    GSX-R 750 Y
    Location
    West Harbour
    Posts
    1,262
    Speedohealer isn't that expensive, especially considering it easily transfers from bike to bike. What advantages does the one mentioned have? How much?

    Nevermind just had a looksie. Looks pretty good I wonder how robust it will be in the end by comparison.
    Cats land on their feet. Toast lands jamside down.
    A cat glued to some jam toast will hover in quantum indecision


    Curiosity was framed; ignorance killed the cat

    Fix a computer and it'll break tomorrow.
    Teach its owner to fix it and it'll break in some way you've never seen before.

  5. #5
    Join Date
    13th April 2009 - 20:17
    Bike
    2010 Yamaha R1
    Location
    Wellington
    Posts
    69
    Quote Originally Posted by firefighter View Post
    Speedohealer isn't that expensive, especially considering it easily transfers from bike to bike. What advantages does the one mentioned have? How much?

    Nevermind just had a looksie. Looks pretty good I wonder how robust it will be in the end by comparison.
    Hahah! Yeah, it's cool and costs $70 USD. Which is about $45 USD cheaper than the Healtech Speedo healer. I like the DRD because it's small. And super easy to calibrate/setup (haven't used the Speedohealer, so have no real life comparison)

    In terms of being robust?....good question. It's enclosed in a little plastic cover and cable tied. So pretty damn water proof. It's installed and then forgotten about unless you want to check your top speed on regular intervals....in which case the Speedohealer would be the way to go.

    Unless one places it too close to the engine and cooks it, I'd say the thing should last for ever!
    ()()
    ( ';')
    ( (")(")
    O O

    Bunnies on motorcycles for life!!!!!

  6. #6
    Join Date
    2nd December 2007 - 20:00
    Bike
    Baby Gixxer
    Location
    Auckland
    Posts
    2,503
    Blog Entries
    7
    We used the ones which have tie downs when we took our bikes over to the SI on both trips we've done so far. The handle bar slips are soft and go easily over both grips. They were great - got them from Motomail.

    Must say, I was getting all excited wondering what kind of exotic contraption for "dancers" you were going on about...

    Ah well at least I could check the pics to see what you were going on about even if they were disappointing!
    I lahk to moove eet moove eet...

    Katman to steveb64
    Quote Originally Posted by Katman View Post
    I'd hate to ever have to admit that my arse had been owned by a Princess.

  7. #7
    Join Date
    13th April 2009 - 20:17
    Bike
    2010 Yamaha R1
    Location
    Wellington
    Posts
    69
    Quote Originally Posted by PrincessBandit View Post
    We used the ones which have tie downs when we took our bikes over to the SI on both trips we've done so far. The handle bar slips are soft and go easily over both grips. They were great - got them from Motomail.

    Must say, I was getting all excited wondering what kind of exotic contraption for "dancers" you were going on about...

    Ah well at least I could check the pics to see what you were going on about even if they were disappointing!
    Haha! I have always thought the name was misleading and kinda ghey....

    Curiosity killed the cat!

    The R1 has pretty broad 'shoulders' and fairings till africa!...hence the difficulty in getting the bike (and another bike) on the back of the ute without getting in contact with the paint work...

    Naked bikes are way easier to deal with. If I had one, I would have stuck with the wunder bra...or what ever it's called


    What's with the names btw?.....hmmmmm
    ()()
    ( ';')
    ( (")(")
    O O

    Bunnies on motorcycles for life!!!!!

  8. #8
    Join Date
    8th January 2005 - 15:05
    Bike
    Triumph Speed Triple
    Location
    New Plymouth
    Posts
    10,218
    Blog Entries
    1
    Quote Originally Posted by merlin View Post
    I first bought the bike bra and found that I couldn't get the angle right without it coming into hard contact with the fairings.
    That's right, I remember now. I had to be careful of the fairing on the VFR.
    Haven't got a fairing for the next trip south in Feb so things might be just a little simpler.

  9. #9
    Join Date
    13th April 2009 - 20:17
    Bike
    2010 Yamaha R1
    Location
    Wellington
    Posts
    69
    How the fuck do you upload to get it to show the picture in the reply???!!!....






    Anyway.

    These are awesome. Definitely easier to use and get right.

    Recommend them hardout!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •