...having just rebuilt my CB350f and getting it back on the track I have a little clutch slip...I put new oil in after the rebuild and used ELF Moto 4hp-eco 10-40...it says synthetic fortified and I am wondering if the clutch is now slipping because I have gained some horses back or if the oil is not the best to use on an older bike/clutch...I am just about to put new friction plates in, but was wondering if anyone new if this oil is to be avoided when I put new oil in..

 
			
 
						
					 
					
					
 
		
				
				
					 Reply With Quote
  Reply With Quote 
						
					 
						
					
 
						
					 Originally Posted by MSTRS
 Originally Posted by MSTRS
					
 
						
					 
						 
				 
						
					 
				 as its been so long since i compared prices maybe there not to far apart these days as they used to be,tell ya what Q i have to go into town tommorow,will call in at the bike shop and compare the prices as you may well have a point though that said i will as i have for 40 or so years continue to use good quality mineral.(old and set in my ways
as its been so long since i compared prices maybe there not to far apart these days as they used to be,tell ya what Q i have to go into town tommorow,will call in at the bike shop and compare the prices as you may well have a point though that said i will as i have for 40 or so years continue to use good quality mineral.(old and set in my ways )Fwiw i have always run it in my V8s with no need to change.
)Fwiw i have always run it in my V8s with no need to change.
				
Bookmarks