Newmanz parts?

**Ivan** · 5th May 2011, 16:30

Hi has anyone used any of the Newmanz 4 stroke parts like this http://newmanz.co.nz/shop/index.php?...roducts_id=205

on a Honda XL125 or CB125 etc???? also has anyone had any luck with using Loncin Piston kits as well???

Just I have a XL125 well kind of its a bit of everything and im putting it together and if possible was going to use these parts

Cheers

Ivan

**Henk** · 5th May 2011, 16:42

I ordered one of those, a CDI and coil to go with it last week for the F5 bike I'm building for Michelle. They haven't turned up yet so no idea if it will work / fit.
I'll do a trial fit when they get here and let you know how it goes.

As an aside I'm still looking for an FXR roller to fit the engine into, have more pieces missing than there at the moment if anyone has one to spare.

**Ivan** · 5th May 2011, 16:46

was just looking on his site and its been weather related problems why he couldnt send parts, hes a nice enough sort of guy so thought id spend some money through him,

If anyone also is after cam specs for these tye of motors here is a list I found

http://www.tighecams.com.au/bikes.htm

**Ivan** · 5th May 2011, 16:47

http://newmanz.co.nz/shop/index.php?...roducts_id=204

this here looks good I can remember the clutches being oh so tight on these old motors

**Kendog** · 5th May 2011, 17:19

I have purchased a few things from newmans with no issues.

**Gigglebutton** · 5th May 2011, 17:42

I have bought some that where great . Other bits needed work done on them to get them to fit. Teezee uses newmans electrics

**Ivan** · 5th May 2011, 18:08

guys im not meaning is he good at sneding parts I know hes good at that

Im meaning has anyone had any luck putting the Loncin parts on the early Honda Motors the Loncin is based off

**Henk** · 12th May 2011, 20:47

Well those bits don't fit on the XL motor with the points on the end of the cam taper on the aftermarket rotor is way too big and the staor plate wants to mount in completely the wrong place and won't fit.
They may fit on the later models with the external as opposed to internal rotor and the points on the stator plate.
Not sure that I'll be able to make it fit at all on the engine I plan on using, looks like an expensive paper weight at this stage, I could lob the lot at Rick since he has the later model engine to see if that will work, if he is willing to try it in the interests of increasing the knowledge pool.