88 GSX600FJ revving problem

[Askelon]

I pulled the carbs out of the bike to drain them, all went well apart from now I cant get the bike to rev below 3k at all. I lubed everything up, tried changing the idle, tried everything I can think of. Even thought maybe its the choke stuck on but it doesnt seem to be that. The bike runs fine but like I said I just cant get it to rev below 3k anymore.

Ive checked the tension on the throttle cable and that wasnt the problem. Im sort of at a loss as to what to do now. Anyone got any suggestions?

[imdying]

Did you fit the carbs to the manifold rubbers correctly, and tighten them up correctly. Sounds like a wee air leak.

[Askelon]

Im pretty sure I did.. They have been on and off a few times with no change though.

[gwigs]

Could be the float levels,check the plugs to see if they are wet...could be flooding.

[Askelon]

All sorted thx. did a clean and resync of the carbs and its all running as good as it did before