Hello
Has anyone had any trouble with an OEM suspension linkage kit from Honda?
The bike shop & I are scratching out heads as to why when assembled and fully pressed, the pins seam to not be long enough. The little end caps or cups do not make contact with the pins.
Especialy on the lower link, the link that connects to the frame. The guys at the shop are certain they have pressed them all the way. And I have checked the bearings and they are correct, 20x26x15 for the tri linkage and 20x26x14 for the lower link.
The pin and cups on the tri linkage should have had thrust washers included in the kit.. they did not come.. however... I just had the old ones installed. And it seams there is about .2mm of clearence between the cup and the pin.
Anybody experienced this ? Or is the bike shop just being too nice to my bearings when driving them in ?
Cheers
Leyton Smith
Bookmarks