I have an old RMX250 I have rebuilt. I bought a complete gasket set and notice a kind of O-Ring and am wondering if it fits onto the front of the exhaust pipe. Any ideas? And fitting the springs to the pipe is gonna be tricky.
Hardcore Biker
I have an old RMX250 I have rebuilt. I bought a complete gasket set and notice a kind of O-Ring and am wondering if it fits onto the front of the exhaust pipe. Any ideas? And fitting the springs to the pipe is gonna be tricky.
"May all your traffic lights be green and none of your curves have oncoming semis in them." Rocky, American Biker.
"Those that give up essential liberty to obtain a little temporary safety deserve neither liberty nor safety." Benjamin Franklin, 18th C.
Forum whore
The o'ring goes in a groove around the header pipe where it enters the cylinder. You need a spring puller which is basically a hook with a t handle, not hard to make one but cheap to buy also.
http://www.sportspro.co.nz/products/...ller_tool.aspx
Hardcore Biker
There was an -ring in the kit that fited = problem sorted
"May all your traffic lights be green and none of your curves have oncoming semis in them." Rocky, American Biker.
"Those that give up essential liberty to obtain a little temporary safety deserve neither liberty nor safety." Benjamin Franklin, 18th C.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks