Any refrigeration supplier will have a bender for that. It's 3/8 more likely than 10 mm by the way.
For the pittance they cost, why make something?
Forgot to get a screaming bender from town, but I got Dilmah tea, even better.
Thinking of doing an ignition advancer on the GN, once I get home I'll have a look to see what the timing specs are, but from memory they're pretty beige. If it bashes the bearings to bits, who cares? They're easy to replace and bloody cheap.
http://www.trademe.co.nz/Browse/List...x?id=495673786
Cross yer fingers, I reckon I can make these look reasonable and they're the exact muffler I've been looking for
If I win 'em I will be a happy fellow
Missed out on the cool mufflers, too bad, not paying more than $80 for second hand mufflers
Finally got home from being up north holidaying.
All my tasty new bits are here, so tomorrow is time to assemble some motor!
Rather tempted to start on it tonight, but it's 2 degrees in the garage
First thing I did when I got home was take all the boxes off new bits to the garage and tear in to the handle bars, I got some MX style black bars off Mossy, I promptly took the bar brace off, flipped 'em and threw them on. Awesome! Thanks Mossy, yer a champ.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks