Could anyone tell me the diameter of the fork tubes on an '81 katana. At the triple clamps.
Cheers
Ola
Obey the hosebeast
Could anyone tell me the diameter of the fork tubes on an '81 katana. At the triple clamps.
Cheers
Ola
Too old to die
37mm as I recall, but I will check and comfirm that
Too old to die
37mm is right
Obey the hosebeast
Aha. That's a bit too butch for my requirements.
Next question:
What bike has clip-on bars and 30mm forks?
In the riders seat
for the H100 bucket? I'd look for a GL145 front end comes with a hydraulis disc and chances are being a Honda the front end will slot straight in with out any mods, you'd still have to make some clip ons though
"If you can make black marks on a straight from the time you turn out of a corner until the braking point of the next turn, then you have enough power."
Originally Posted by scracha
Obey the hosebeast
Yep, for the bucket. I have a hydraulic disc front end, I'm just after some clip-ons.
gee wizzz
bung-In the awd days we just used to weld them up
With the honda mb50 I used to turn the top tripple clamp upside down
--the other possibility would be to see if you can get a set of Z bars
they in effect gave you clip ons
To see a life newly created.To watch it grow and prosper. Isn't that the greatest gift a human being can be given?
No8 Wire Extraordinaire
Ohhh nooooo!!!
My poor innocent little H.
Don't you look at my accountant.
He's the only one I've got.
Obey the hosebeast
It's far from innocent. It may have been once, before you got near it.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks