Wanted RGV250 engine

[Asher]

If your in no hurry to sell that bottom end is it ok to wait 2 weeks to sell it to me? I just started a new job and wont be getting paid for 2 weeks

[manxkiwi]

is yours the one I just bought on trademe? lol..

It's mine! He he. Have emailed you, getting a price today. Cheers.

[imdying]

Sure, I'm in no hurry to sell it... you can never have too many bits in the garage ;-)

[Fast Eddie]

It's mine! He he. Have emailed you, getting a price today. Cheers.

haha good man! thought I had seen a username with manx in it like the email addy

i dialled in some numbers into the nzpost rate calculator and postage fees don't look too bad actually. see what the post shop says.

Cheers manx

[imdying]

Are you sure it's leaking? Sure it's not just shitty Japanese castings that look like cracks? Have you completely stripped your old bottom end yet? Might be worth doing, just for the experience if nothing else. I have a 1/4 and 3/8 torque wrench suitable for these little shitters if you want me to come round one night whilst you torque it all up.

[Asher]

Yeah its dripping oil onto the LH expansion chamber and my garage floor although not alot. I figure for only $150 i might aswell replace it. I havent stripped the engine out yet, i was going to wait till i get new pistons and do a good check over then.

Im 95% sure its cracked, if it was only in one spot i would have probably looked into repairing it but its in quite spots. I will get some pics of it tonight.