anyone got one? i've just been quoted 190$ for replacement unit ex-japan. all i want is a washer. just one washer!
failing that, anyone got bright ideas about an engineer that'd sort one out or a workshop i can borrow to do the same?
anyone got one? i've just been quoted 190$ for replacement unit ex-japan. all i want is a washer. just one washer!
failing that, anyone got bright ideas about an engineer that'd sort one out or a workshop i can borrow to do the same?
Go to a hardware store. They have tools and small piece of metal stock. You could make it in half n hour with a dremel (which you'd then still own for next time!!!), or a little bit longer if you're a tight cunt and only want to pay for basic hand tools. You'd be surprised how often you'd use a small file set, and they're dirt cheap Small files are oddly soothing, and even making simple things gives a reasonable sense of accomplishment... nothing like hand crafted
I had to make one for the gsx550ef speedo drive I just sold. Must be common fault.
I have one I just pulled out of my bucket bike. What sizes is yours.
I have evolved as a KB member.Now nothing I say should be taken seriously.
43.3 OD
ext tabs 4mm out, 5mm up
25 ID
int tabs ~2mm but worn so may be more??
plate 1.6mm thick...
do you have a part number for it is it available separately or does it come with the speedo drive?
or draw it out and get it laser cut... don't worry about balance etc, the weight is so minimal and it's right on the axle so wont matter a bit. what actual model is your bike?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks