Anybody have some needle jet spacer washers or where to get some?

[nzspokes]

Anybody have some needle jet spacer washers or where to get some? I need some for makuni carbs.

Cant seem to find any for sale.

[spanner spinner]

northen acc bring these in, your local dealer will deal with them. Your local parts guy will have to chase them to get them to find them though. If you have no luck with them get hold of http://www.sudco.com/ they will stock them.

[nzspokes]

northen acc bring these in, your local dealer will deal with them. Your local parts guy will have to chase them to get them to find them though. If you have no luck with them get hold of http://www.sudco.com/ they will stock them.

Oh good, ive got a good local guy that looked online and they weren't on there. I will get him to ring.

[DrunkenMistake]

if you know the exact thickness you need,

Go to a fasteners supplier.

[nzspokes]

if you know the exact thickness you need,

Go to a fasteners supplier.

Apparently they dont from the ringing around I did today.

[DrunkenMistake]

Try EDL fasteners thats where I got mine from there is one in Auckland,
You just need stainless washers usually its either 0.5mm or 1mm thickness
http://www.edlfast.co.nz/

[rogson]

You can get 0.5mm thick steel and 1mm nylon washers from an electronics components supplier such as Jaycar.
Or, get a Tamiya shim washer kit from a model shop. The kit contains 10 of each 0.1mm, 0.2mm and 0.3mm washers.

[nzspokes]

You can get 0.5mm thick steel and 1mm nylon washers from an electronics components supplier such as Jaycar.
Or, get a Tamiya shim washer kit from a model shop. The kit contains 10 of each 0.1mm, 0.2mm and 0.3mm washers.

Cheers, got some from Jaycar.