Page 2 of 2 FirstFirst 12
Results 16 to 17 of 17

Thread: Electrical issues - BMW R1100r - Hall Effect sensor?

  1. 21st August 2012, 11:51 #16
    CRM's Avatar
    CRM
    CRM is offline Riding Qwerty
    ♂
    Join Date
    8th November 2007 - 13:05
    Bike
    CRF250L Rally
    Location
    Whangarei
    Posts
    764
    Got her back yesterday going sweet again. The wires from the Hall Effect sensor were virtually bare copper They tested the sensor and it was fine so just replaced the harness part. Good job by Snow Bros auto electrical and Mark from Shaws. Mark changed the fuel filter too.

    Thus endeth the tale of the electrically defective bavarian motor not-werken device
    Reply With Quote Reply With Quote
  2. 21st August 2012, 22:02 #17
    BMWST?'s Avatar
    BMWST?
    BMWST? is offline Forum whore
    ♂
    Join Date
    4th October 2008 - 16:35
    Bike
    R100GSPD
    Location
    Wellington
    Posts
    10,045
    Quote Originally Posted by CRM View Post
    Got her back yesterday going sweet again. The wires from the Hall Effect sensor were virtually bare copper They tested the sensor and it was fine so just replaced the harness part. Good job by Snow Bros auto electrical and Mark from Shaws. Mark changed the fuel filter too.

    Thus endeth the tale of the electrically defective bavarian motor not-werken device
    good outcome well done
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules