Jam and tarts....
There are some fun space issues in the DR600 motor so I can't seem to get a bearing/pulley puller on the flywheel.
Has anyone got a DR600/500, SP600 or pre '96 DR650 flywheel tool that I could borrow?
Or anything else that runs a 42x1.5mm internal thread on the tool?
Originally Posted by Paul in NZ
Alloy, stainless and Ti polishing.
Bling your bike out!
PM me
No8 Wire Extraordinaire
check torpedo7, should be so cheap as to not have one would be silly.
Don't you look at my accountant.
He's the only one I've got.
Jam and tarts....
Can't seem to find one there
They're going to cost about $70US from overseas, I'll flick a few emails around the shops and see what they can do.
I'd rather not pay to have the locals bash it with a hammer
Alloy, stainless and Ti polishing.
Bling your bike out!
PM me
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks