Looking for a NZ supplier of these:
http://www.turnabike.com/products/saddle/
Small dolly for the center stand so you can swing bike about on it.
An engineer types think it expensive to make?
The original Disco
Looking for a NZ supplier of these:
http://www.turnabike.com/products/saddle/
Small dolly for the center stand so you can swing bike about on it.
An engineer types think it expensive to make?
"Speed has never killed anyone. Suddenly becoming stationary - that's what gets you."
Jeremy Clarkson.
Kawasaki 200mph Club
Forum whore
have seen the car version for sale somewere, "Go Jacks" or something like that, wernt to badly priced, would work with a bike i think. will have a sus out where there wereOriginally Posted by Disco Dan
Dale Kerrigan: If there's anything Dad loved more than serenity, it was a big two stroke engine on full throttle!
Highway Biker
Not at all. You could get the body lazer / water cut from 10mm aluminium plate for around $100. Then you just need a bender (friendly local fabricator could help) and a set of 4 decent castors. The whole thing could be done for $200 - $250
Hardcore Biker
close but not quite right
http://www.trademe.co.nz/motors/car-...-533016517.htm
Boys can't ride broken toys.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks