Haynes gn250 workshop manual, is there such a thing?

[bosslady]

Haynes gn250 workshop. Does anyone have one they would kindly let me copy or do you have a copy? was told it would be a good idea to get one of these

[ducatilover]

http://dl.dropbox.com/u/26633588/GN250%20Manual.pdf This should link you to my copy (I think)

[mtys]

Hi is this still available?
I've got a 2005 GN250. I've been trying to figure out what one of the screws is on my carburetor (assuming its a Mikuni BS34SS carb). It appears to be non-removable. The air-fuel mixture screw is located on the top according to schematics so not sure what this additional screw on the side is. The schematics don't have the screw either.
A workshop manual may be able to help?
Thanks!

[AllanB]

All you need is a big screwdriver a hammer and if you go by Cassinas recommendations a can of CRC.

[Akzle]

there is literally nothing on a gn250 you can't do with two screwdrivers, a hammer and a spanner set. i'm surprised they even bothered writing a manual.
epic fucking dredge though, newguy. you ask if it's available, did you try the link?

[Black Knight]

I own a Haines manual-I use it as a door stop on a hot day in the workshop,this is its only use.