A question for electrical engineers

[Akzle]

Housing only goes as far as the collars with the through bolts undone. Solid shaft all the way through too.

there's one on the back, too??

i think you're doing it wrong.

Freeze spray.
Fucked if I know where to get it from down your way, seeing as everyone in Gore is gay and wants warming lube

doubt it would work on this scale. although, if you're that way inclined (and are sure it will actually pull off), chuck it in the freezer overnight, then put the gas torch on the collar ONLY, else you're going to crack some shit.

[neels]

Do you have a local engineering shop with a big press you could borrow for a doz?

As for heating/cooling, another option is packing dry ice around the shaft, and then hit the collar with some heat and a big puller.

[unstuck]

CMG the ones who make it say the collars have to come off before I can go any further. Already fucked 2 pullers on this stupid motor, mind you the guy that owns it and has been doing up the plates on it is a fucking goreillar, and if he has put some pressure on the spanner doing up the plates then it will be snug, to say the least.

[unstuck]

Got a decent press, will just have to make up something like a beam puller to go around collar. Mate has a bearing heater that I will try leaving on overnight, and see what happens in the morning.