Results 1 to 2 of 2

Thread: GN250 Cafe/Bobber/Brat bike for a laugh

  1. #1
    Join Date
    28th February 2011 - 17:50
    Bike
    ........
    Location
    ...
    Posts
    464

    GN250 Cafe/Bobber/Brat bike for a laugh

    Ok so I am building a GN250 ( butchering ) & have been trying to figure out what size tyre I can squeeze on the bum of this thing .

    I have heard of guys ( & girls ) putting a 130 from the front of a sprot bike on the rear of them ...

    any other ideas ?

    I am aware that this is KB & that good ideas are few & far between .

    The bike cost me $40 & a box of piss, I am also picking up another fame from a nice chap next week sometime as the one that I have was de reged & the cost of putting it through out weighs the cost of the frame that I am getting which is still live.

  2. #2
    Join Date
    26th February 2007 - 23:15
    Bike
    In the rubbish bin
    Location
    NZ
    Posts
    2,364
    Quote Originally Posted by nzmikey View Post
    Ok so I am building a GN250 ( butchering ) & have been trying to figure out what size tyre I can squeeze on the bum of this thing .

    I have heard of guys ( & girls ) putting a 130 from the front of a sprot bike on the rear of them ...

    any other ideas ?

    I am aware that this is KB & that good ideas are few & far between .

    The bike cost me $40 & a box of piss, I am also picking up another fame from a nice chap next week sometime as the one that I have was de reged & the cost of putting it through out weighs the cost of the frame that I am getting which is still live.
    Get a tape measure... and measure clearance both sides of the rear tire. Then subtract a bit for luck, then subtract more for expansion, then you have the size you can go to.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •