ER650 cases

[neil_cb125t]

Hey - so my replacement cases arrived, the lovely gentleman decided to pull them apart with a screw driver literally..... there are marks like this everywhere incl where the main bearings sit....yay

If anyone has a spare set let me know, and if you know an American that sells crap on ebay slap him for me.

[steveyb]

Devcon will fix that, no worries.

[crazy man]

tig them up and file flat with a new mill file

[neil_cb125t]

Really I thought these were junk, ok who is DEVCON, if they can be welded and re machined then I have a few contacts

[malcy25]

ok who is DEVCON,

a broke road racers friend!! Google it, it's a liquid metal putty thingymajig.

[steveyb]

devcon.co.nz
Blackwoods Protector are a distributor.

[Kevin G]

devcon.co.nz
Blackwoods Protector are a distributor.

I have a better solution... much quicker and cleaner than devcon...its called rapid fix
http://www.rapid-fix.com/HOME.html
Got me out of the shit this season after a stupid mistake...
Thanks to Budda for putting me onto it.

[jellywrestler]

Really I thought these were junk, ok who is DEVCON,

long shot
http://www.youtube.com/watch?v=IIEVqFB4WUo

[swarfie]

Really I thought these were junk, ok who is DEVCON, if they can be welded and re machined then I have a few contacts

Selleys "Kneed-it" will do the same as Devcon and both have the added advantage of no heat which will cause distortion which will happen to some degree with welding.

[Mental Trousers]

I think the issue here is some fuckwit thinks it's ok to pry cases apart with a screw driver. It's highly likely that said fuckwit will breed overspring. This is an unacceptable state of affairs.

[NAR RG500]

I think the issue here is some fuckwit thinks it's ok to pry cases apart with a screw driver. It's highly likely that said fuckwit will breed overspring. This is an unacceptable state of affairs.

If some rough bastard didn't down shift when the engine was already spinning above the red line then there never would have been a need for new cases.

[steveyb]

That's how they both ended up together.
Birds of a feather and all that......

Rapid Fix looks pretty good.
Possibly better for repairing cracked/broken bits than just filling in a small hole?
What say you?
Where get from?

[Mental Trousers]

If some rough bastard didn't down shift when the engine was already spinning above the red line then there never would have been a need for new cases.

Rough bastard buys from rough bastard. As steveyb said, birds of a feather eh.

[AllanB]

This two pack stuff is very impressive if you are willing to use those cases. I've used it to repair stuffed threads on old stuff that some other bugger butchered and works well.

http://www.jbweld.com/product/j-b-weld/


Usually available on Tm and I have seen in K-mart

[steveyb]

Devcon with different printing on tube. Even the same tubes.

Devcon is available in different formulations for when you want to get real picky about what you are doing.

I have used JB-Weld before too. As said it is the same thing, so works exactly the same. So good to go if that is what you can get.