Went to get my bolts and the pussies had shut up shop and gone home!
- So what do you need?
Don't you look at my accountant.
He's the only one I've got.
I haven't measured yet. Pretty specific sizing required. I can wait so no rush for this weekend. I need to do some work on the 400 as I plan to take that to the BoB.
A carb idle screw was found at the track today.
If it's yours PM me.
Life is a lesson-if I bother to listen
fun day in reverse , need to sort my wets but had some good racing with the bro. also thanks to fish and helpers ..good stuff
i was there today for about 3 minutes!
I had a good day after getting my wets on. Sorry I took some places with lapped riders. It was fun to have the 50 out but I was weary of it. Caleb got caught out and went down. Good to see Fishy going hard in the last race. Getting back on form after a long break.
I will have to do something with my gearbox before the next one as it was quite a problem.
Good to see those that turned up and a blast in reverse direction.
Good to see you had the 50 out there, just a pity that it was wet. I pitched up, but decided to pike. Good thing to as it turns out, my water pump was broken.
Don't you look at my accountant.
He's the only one I've got.
I did two runs Caleb two and Rich one. It was good to watch. Rich got lost in the gears but I think he enjoyed it. Caleb won a B race on it. I must spend some time on the carb to try and get it running better.
Dose anyone have a selection of jets for a 28 Mikuni flat slide pleas PM me.
Well I do but it depends what size you need to be near. can vary heaps from bike to bike. so if you have say a 240 then post it up so people can see what you're near. Likely you have Mikuni hex jets, but I have seen flatslides with button jets as well.
Don't you look at my accountant.
He's the only one I've got.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks