Bucket enduro, Wellington 15 September

[F5 Dave]

Well you were in 2nd for those laps & ahead of Fish yeah? Not a bad shake of the stick.

[koba]

Sux. I waited around and watched the last race. I saw you on the FXR and did wonder.

Yeah, My own dumb fault.

I've rebuilt it with a 2nd hand piston (And a LOT of cleaning work) but will put in a new one shortly. (Should be in at TSS today)
I need to revisit my ignition setup, I've also machined the head to be a bit more conservative as the compression was a bit on the high side given I'm just using pump petrol.

[Henk]

Koba

Saw you in the kartsport pics on both Helen's bike and Adrian's,did you tag them the half hour? Or we're you just out playing?

[F5 Dave]

. . .I need to revisit my ignition setup, I've also machined the head to be a bit more conservative as the compression was a bit on the high side given I'm just using pump petrol.

Thought you were solid on your choice of ign?

This probably won't sell, maybe make him a cheeky offer

http://www.trademe.co.nz/Browse/List...x?id=637217804

14:1 should be fine on pump gas. Are you higher than that??

[Bert]

Had a hoot of a day; so good to be back riding again.
Slight point of difference riding a four stroke bucket for the first time.

Nice to finish a few races; and a wee lay down...

Some great photo care of Jessica van der Merwe via the NZM4R Facebook page.


https://www.dropbox.com/sc/xqepzxdkmxd73nj/dVLaIfmQG#/

Wicked, now time for BOB.

[F5 Dave]

Yeah ppretty good. Glad got some dry racing to get some mojo back. Ordered some wets.

[koba]

Thought you were solid on your choice of ign?

This probably won't sell, maybe make him a cheeky offer

http://www.trademe.co.nz/Browse/List...x?id=637217804

14:1 should be fine on pump gas. Are you higher than that??

Will have to check that link later, no TM at work.
I was at 13.2:1 so should have been OK.
I had to make a cut anyway because the squish band was wrong, it was tighter on the inside circumference so that may not have helped.

My ignition depends on what I can get cheap, I expect I will need to run with the current hardware for now but may be able to swap electrickle bits to get a better setup.

My main issue is the way I have been setting it it, there is no keyway location at the moment so I need to do some work to get a positive location and thus consistenet and accurate timing settings.