The Bucket Foundry

[Carel H]

Well. at least it's not a direct copy, LOL...More "school of Aprilia" Husa's moulds I assume.

Looking at the finished cylinder, and particularly the small ridges on the inside of the water jacket, can anyone come up with a reason for them ?
Is it just an artistic flourish on the part of the patternmaker or is there a purpose to them ?

Could be a cooling plate. Where the casters want the solidifying to start. Had a magnesium casting done in Germany and the casting had something similar. And if the Germans do something, they do it for a reason!

[F5 Dave]

What were the leather shorts about then?

[Carel H]

What were the leather shorts about then?

I think heat shielding.

[husaberg]

Well. at least it's not a direct copy, LOL...More "school of Aprilia" Husa's moulds I assume.

Looking at the finished cylinder, and particularly the small ridges on the inside of the water jacket, can anyone come up with a reason for them ?
Is it just an artistic flourish on the part of the patternmaker or is there a purpose to them ?

id suggest ón the gen Aprilia it where the multiple infill sections of cores are added, as it appears undercut there, it might just be the only way to install them might just be as thin sections slipped in from the side.
the other (Flettner)ones are cast as two seperate sides left and right.

[WilDun]

What were the leather shorts about then?

Have you ever tried "wandering" in the wet mountains in leather longs?

[husaberg]

Have you ever tried walking around in the wet mountains in leather longs?

[ken seeber]

Maybe instead of all buying a bit of a Ryger (see ESE) we could all chip in and get one of these:

http://www.humtown.com/hp/products/3...d-cores-molds/
http://www.exone.com/

[husaberg]

Maybe instead of all buying a bit of a Ryger (see ESE) we could all chip in and get one of these:

http://www.humtown.com/hp/products/3...d-cores-molds/
http://www.exone.com/

No names for the cheque, just send cash.......
I bet flets been casting today hes gone all quiet.

[F5 Dave]

Just make it out to Christian Adult Society Helpers. Yes that is a long name, just the initials will do.
(Credit to the New Statesman)



Now if I could just find my cheque book. Think I left it in the previous century.

[Pursang]

Maybe instead of all buying a bit of a Ryger (see ESE) we could all chip in and get one of these:

http://www.humtown.com/hp/products/3...d-cores-molds/
http://www.exone.com/

May I please have one in Cast Iron, small fins, with a flange on the bottom?

[diesel62]

Can I ask what the thermal lining. Thanks

Sent from my SM-G900F using Tapatalk

[husaberg]

Just make it out to Christian Adult Society Helpers. Yes that is a long name, just the initials will do.
(Credit to the New Statesman)

Now if I could just find my cheque book. Think I left it in the previous century.

I was thinking about that one but wasn't it the christian appraoch to society handbooks
9 min

[Lightbulb]

Husa, is that 3d printed or is it from a flexible core molds?
Neil

[F5 Dave]

Probably was but I think he used that joke a few times on constituents

[WilDun]

I am very interested in that printing technique for sand casting patterns (and I guess I could eventually get used to the lines) but would be much more interested in the printed metal powder (non pattern) products ready to be sintered into a finished metal product afterwards. - Guess it's already in production for some stuff, I dunno.