I was looking for a picture of something and came across one I had posted in the thread.
But every time I go past a second hand shop I always have a rummage through the tools for that amazing tool I never knew I needed.
Odd thing is you hardly ever seem to see real interesting stuff just the same old crap.
where do all the dolly hammers, 3 leg pullers, clamps and spoke shaves go
Second hand tool shop in Jackson St, Petone has some diamonds among the dross. Prices tend to be a bit up there.
it's not a bad thing till you throw a KLR into the mix.
those cheap ass bitches can do anything with ductape.
(PostalDave on ADVrider)
Never see anything in there worth the iron oxide shite in drawers.
Maybe I should return.
Don't you look at my accountant.
He's the only one I've got.
Go soothingly on the grease mud, as there lurks the skid demon
Used mine today. So much more control when you have leverage to spare
Don't you look at my accountant.
He's the only one I've got.
Just found mine.
On top of the water cylinder?
http://static1.shop033.com/resources...C/15046268.jpg
A knob compressor?
Cigar slitter?
"Shout! Shout! Let the clutch out!" Gears for Fears
Cable oiler..........
I have had one for about 30 years
https://www.youtube.com/watch?v=crJoG6MsHjQ
Guy I used to work with modified sockets the same as that to undo Honda centrifugal Filter nuts on the singles and clutch centre nuts.
Far cheaper than the proper Honda tool.
Note as a general rule the rear axel can be screwed in used as a puller on most Honda singles flywheels.
There are currently 3 users browsing this thread. (0 members and 3 guests)
Bookmarks