Sidedraft webers.I did this on a pretty old 40DCOE. Replace the butterfly spindle ball bearings with sealed ones, make sure the float chamber sees boost pressure (float bowl is vented to air box) and replace the brass weber floats with plastic dellorto ones. That was about all it needed aside from jetting.
The brass floats would collapse under pressure and sink, the dellorto one were fine.
Webers look quite cool hanging out the side of a V engine
it's not a bad thing till you throw a KLR into the mix.
those cheap ass bitches can do anything with ductape.
(PostalDave on ADVrider)
Bookmarks