ZXR:
Runs like shit? Can you elaborate?
You can buy the emulsion tubes from overseas, don't buy second hand carbs
For a basic slip on can, pull the jets out of cyls 2/3 (122 I think, from memory) and chuck them in to numbers 1/4, then buy the size up from Nikau on trademe, for $6 each.
CBR, hesitation under 3k?
This all depends on load and throttle position, so can't really say over teh internets.
But I would look at doing a carb sync, then a set of plugs. Because it's cheap and it's nice to pamper your bitch.
Check the air filter, intake boots etc etc etc
After these you can go set the carbs up.
Or you could just not be used to having a small 4cyl (mind you, my Bandit pulled from any revs with no flatspots and made 45hp too, could load it up in 6th from 2lrpm without flatspots)
Edit, just read you have an aftermarket pipe.
Does it go flat feeling and hollow sounding or "wet" feeling
Bookmarks