JIS screwdrivers

[sil3nt]

Anyone know if you can get these in NZ?

For those that don't know what they are:
http://www.webbikeworld.com/motorcyc...-screwdrivers/
http://www.instructables.com/id/When...rial-Standard/

[T.W.R]

Try a topline supplier for electricians, they'd be the most likely.

[Gremlin]

I've put a call into Tool and Industrial to see if they can source something

http://toolandindustrial.co.nz/shop/

Should get an answer later this arvo...

Yes... it sounds like I should have a set... just in case y'know

[Laava]

Alternatively you could go to a builders supply and buy the bit that fits into a gib screw gun. I am pretty sure it is a number 2 JIS and they are made of very durable steel. Only snag is that it is a bit and about 130mm long. Plenty of std fitment handles about though.
EDIt, i was wrong they are no2 phillips.

[sil3nt]

Will probably end up ordering from the states.

I needed this the other week:
http://www.vesseltools.com/hand-tool...ypage.tpl.html

Had to use a dremel to get a standard impact driver to work.

[nzspokes]

I think the screw drivers we sell at work could be JIS. Will look tomorrow.

Could be wrong. Dont pay them any attention.