Race tail red light LED in rear tight wire?

[kiwi cowboy]

I have a fzr750 race bike that I am putting a permanent red rear light on for wet meets.

I have a 10-30v led light from repco part no RLMRBL and have a fuse box I was going to wire straight to the battery with the fuse box inline to a switch but I also have the wiring from the light switch on the handle bar I could use.

My question is can I use the switch on the wireing harness and just hook the wires up and use the switch on the bars to turn on or off or will this damage the harness.
If I can use the switch should I use the fuse holder before the light?.

I have heard some thing about needing resistors if using leds but don't know anything about wiring.

Any advise???.

[Drew]

Straight in the standard wires is fine.

[Daffyd]

I have heard some thing about needing resistors if using leds but don't know anything about wiring.

Any advise???.

If it's 10-30V you won't need resistors.

[kiwi cowboy]

Straight in the standard wires is fine.

cheers drew so I don't need any type of resistor or fuse?.

What are the resistors I have been told about?.

[Drew]

cheers drew so I don't need any type of resistor or fuse?.

What are the resistors I have been told about?.

Nah, the only time ya want them is in the indicator circuit.

[Drew]

Standard circuit is fused already.

[kiwi cowboy]

Nah, the only time ya want them is in the indicator circuit.

Cool thanks for that.
All I got ta do now is figure out how the hell im supposed attach the bugger lol.

[unstuck]

What are the resistors I have been told about?.

You know those sheep you screw on a regular basis, the noises they make when you ram it in without lube, is the sound of resistors. Hillbilly retard you.