Forum whore
The TM28 pumper slide carb on my DRZ250 seems to need a lot of force at the throttle. The issue seems to be a too heavy gauge return spring on the main shaft. Cables move freely, throttle has no binding. Anybody know if this is a common complaint or of any fixes.
Anorak
The only bikes i have used with tm28s were all 2 strokes and i never noticed they were heavy.Originally Posted by SVboy
But Four strokes tend to have strong return springs to prevent them sucking the throttle open on over run.
i would say the cable has been kinked or needs oiling.
Kinky is using a feather. Perverted is using the whole chicken
In the riders seat
Rode one yesterday, seemed fine to me, it's lighter than the TM28 on my Bucket
If you're doing Amberley swing past home on the way back and compare, I'll be up there on my RMX #83 and Jumbo Transit van
"If you can make black marks on a straight from the time you turn out of a corner until the braking point of the next turn, then you have enough power."
Forum whore
Cheers for the offer kick. Enjoy the mud today?
In the riders seat
It wasn't too bad, just that stretch in the bottom of the gully, bike took a fair bit of cleaning though
"If you can make black marks on a straight from the time you turn out of a corner until the braking point of the next turn, then you have enough power."
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks