Hi,
I'm after a Honda Goldwing engine for a project. Ideally a 1500 but an 1800 would work too (I am unsure if the 1800 is a longer engine though? Space is tight)

I really only need a bare engine at the very least however the manifolds could be handy for the flanges to build out from. I have asked about the wreckers but so far only one has been found and its a bit too flash for my budget Even a non-running engine would be handy because my project idea in mind has yet to be be proven to work out until I can actually nut it out on the bench.

I'm just hoping that someone on this forum might just have 'that old crashed bike collecting dust behind the shed with an engine that was fine ten years ago' sort of thing kicking about

otherwise any help or hints at where I might try for an engine would be happily accepted!

Cheers all,

Alex.