Results 1 to 3 of 3

Thread: Hyosung gv250 clutch too loose after replacing.

  1. #1
    Join Date
    16th December 2018 - 19:45
    Bike
    2015 hyosung gv250
    Location
    Auckland
    Posts
    1

    Hyosung gv250 clutch too loose after replacing.

    I replaced my clutch cable on my hyosung gv250, however there seems to be no tension when pulling the clutch. Any thoughts, suggestions?? Thanks in advance

    https://youtu.be/ouaQekf2aGg

  2. #2
    Join Date
    28th January 2015 - 16:17
    Bike
    2000 Ducati ST2
    Location
    Lower Hutt
    Posts
    1,274
    Check your adjustment at both ends - there's usually a barrel and a locknut, pushing on the cable sheath, to set the cable tension.

    Edit: finally had a moment to look at the video and yeah FJ Rider's right. Time to get the proper cable.

  3. #3
    Join Date
    1st September 2007 - 21:01
    Bike
    1993 Yamaha FJ 1200
    Location
    Paradise
    Posts
    14,126
    Blog Entries
    2
    I recall may years ago ... an acquaintance of mine wanted a rear tyre for his old 750. It had been fitted with a tubed tyre but the dealer only had a tubeless. Said dealer assured him it would fit his bike and would be better than the original tubed ones.

    He took it back a few hours later ... bitching it wouldn't hold air pressure.

    Anybody guess what the issue was ... ??
    When life throws you a curve ... Lean into it ...

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •