There no way I'm getting a spanner in there. So how can I get it undone so I can remove the O2 sensor.
There no way I'm getting a spanner in there. So how can I get it undone so I can remove the O2 sensor.
Something like this? These are for brake pipes, it may be possible to get tube sockets with a cutaway to perform the same function
it's not a bad thing till you throw a KLR into the mix.
those cheap ass bitches can do anything with ductape.
(PostalDave on ADVrider)
Flare nut wrench
it's not a bad thing till you throw a KLR into the mix.
those cheap ass bitches can do anything with ductape.
(PostalDave on ADVrider)
or maybe one of these would be better https://www.amazon.com/ABN-Oxygen-Se...xpY2s9dHJ1ZQ==
it's not a bad thing till you throw a KLR into the mix.
those cheap ass bitches can do anything with ductape.
(PostalDave on ADVrider)
Excellent thanks. Off to repco.
https://www.repco.co.nz/en/tools-equ...491/p/A1218942
Is the O2 sensor goneburger anyway? or are you refitting it?
To see a life newly created.To watch it grow and prosper. Isn't that the greatest gift a human being can be given?
Ha! I never knew those tools existed. I don't need one but they look so cool I'm going to buy one anyway
High miles, engine knock, rusty chrome, worn pegs...
Brakes as new
take the exhaust clamp off then access should be a peice of piss
I think it's buggered. It was off for a couple of years after O2 blanks got fitted, then it was refitted when a booster plug got installed and the engine started running rough when at constant speed. I unplugged the booster plug but it didn't help so I've ordered new O2 blanks.
What about a tool made specifically for the job? That might work.
https://www.repco.co.nz/en/tools-equ...182/p/A1226542
Well the 22mm O2 sockets they had are too big. I tried a few flare nut wrenches, but they're too fat to fit between the fins. The only other option is a O2 socket set, but I'm not forking out for that for a one off job. Looks like the best option is to take it to the bike shop to have it done.
Just watched a vid of the finned collar being removed and it looks easy enough. Will give that a go when the O2 blanks arrive.
So now I need to unclip these electrical connectors that have tabs on three sides that need to be pushed in to remove. Any ideas as I don't have four hands?
Nevermind, I got it.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks