As the title states, I need some help with an electric motor.on a drill press it's a 2 speed 3 phase motor 6 wires coming from the motor.
The 2 speeds are a single winding not 2 separate ones.
I have a good collection of contactors and switches, I have tried a few things but am slowly losing my mind!
Any help would be appreciated.
I have had the motor running by hooking leads 1 2 and 2 to power and 4 5 6 tied together and power to 4 5 6 with 1 2 3 capped off, what I need is to switch betwee the 2.
I am almost at the point where I am going to buy a VSD drive and wire the bastard in high speed.
Bookmarks