Groan. The fucking wiring is taking me forever.
Think this is day4. (I haven't been overly motivated). Just gotta hook up the aftermarket dash now...and figure out which loom branch I mistakenly hid the rear brake light switch wires.
Groan. The fucking wiring is taking me forever.
Think this is day4. (I haven't been overly motivated). Just gotta hook up the aftermarket dash now...and figure out which loom branch I mistakenly hid the rear brake light switch wires.
Don't you look at my accountant.
He's the only one I've got.
My current project is eating an enormous pie. At 8pm, the next project will be mowing the lawns. Again.
If a man is alone in the woods and there isn't a woke Hollywood around to call him racist, is he still white?
Yup. In early October 2017, the Department of Internal Affairs issued notice to remove two of Destiny Church's biggest charities, Destiny International Trust and Te Hahi o Nga Matamua Holdings, of their charitable status. Destiny Church took immediate legal action and subsequently to date they still retain their charitable status with the Department of Internal Affairs.[72]
In late October 2019, the High Court restored the charitable status of Destiny International Trust and Te Hāhi o Ngā Mātāmua Holdings. Destiny's lawyer Ron Mansfield confirmed that the two charities were complying with the law.
https://en.wikipedia.org/wiki/Destin..._(New_Zealand)
it's not a bad thing till you throw a KLR into the mix.
those cheap ass bitches can do anything with ductape.
(PostalDave on ADVrider)
Hmmmm, where and how to mount the speed sensor.
Front sprocket is the tidy option, but it'll be quite the bastardto fab a sprocket cover to hold it.
Tidying up the shed, found a few things I thought I'd lost forever, plus about 6 or 7 ice-cream containers full screws to sort out. Gib fix bugle head, rwinfasts, posidrive , square drives, in all sorts of lengths. Then there are the slotted wood screws, PKs, metric and imperial threaded, nuts, washers and so on. Wondering if the remaining week or so will be enough
it's not a bad thing till you throw a KLR into the mix.
those cheap ass bitches can do anything with ductape.
(PostalDave on ADVrider)
Only got 2 bikes in the garage, one for work and one for play. Both of them recently serviced, so now seemed like the time to do a deep clean. Wash, detar and then into it with the clay bar. The Busa came up damn near brand spanking, bar the odd stone chip, with the FJR not too bad either. Next up the nano coat onto the paintwork, glossy and slippery as fuck sums it up. Polish up the shiny stuff, and really hanging out for a ride, well end of week one actually
Two cars, done the same, wash, detar, clay bar the paintwork. Nano coat the paintwork, nice result. Vinegar to clean water spots from the glass and mirrors.
Looked at my work ute...same despite it only being a few months old.
Bit of spring cleaning at home, no kids and near new house, so apart from some reading and Youtube surfing, slowly going bonkers![]()
Working from home only kept me busy for a few days, now I can't wait to get back to work, same as most folks I guess![]()
Had a GSX750 tank dropped to the mailbox by the neighbour, all sterilized with methylated spirits.
Looked like colander on one section underneath.
A bit of acid & the big old electric soldering iron was the best home solution I had.
If it was on a visible part of the tank I would have kept at it until it was completely flat.
got the bottom all fitted and tacked it . tomorrow I will fully weld it didn't put a fuels tap mount in .I decided on a hose straight off the tank with a inline tap and filter
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks